|
The solid state Electronic controls allow for precise control of the room
temperature conditions while allowing minimum and maximum control set points.
A dual set point is provided on the heating/ cooling unit for individual
heating and individual cooling set point temperatures. This unit is equipped
with a primary air sensor for automatic change over for cooling and heating.
The EFS heating and cooling unit is available in three configurations for
application versatility.
The first configuration is a self-contained unit when the temperature sensor
mounted in the induction guide of the diffuser. The recommended
application of this unit is the interior zones and perimeter zones where the
exterior "skin" heat loss is 250 BTUH/linear ft. or less. The
second configuration is a self-contained unit with the set point controls
mounted under the diffuser appearance panel and the remote temperature sensor
mounted.
It is recommended that this unit with the remote sensor (thermistor) be used
on perimeter applications that exceed 250 BTUH/linear ft. "skin" heat loss and
or applications where the ceiling height is in excess of ten feet.
The third configuration is a self-contained unit with remote set points and
integral temperature sensor (remote Electronic thermostat). This unit may be
used in all applications where easy access to the set point adjustments are
desired. |
BACK